IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-41
show ipv6 routes
Displays IPv6 Forwarding Table.
show ipv6 routes [ipv6_prefix/prefix_length | static]
Syntax Definitions
ipv6_prefix/prefix_length IPv6 prefix. Restricts the display to those routes starting with the speci-
fied prefix.
static Restricts display to statically configured routes.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
If you do not specify an option (e.g., “static”), all IPv6 interfaces are displayed.
Examples
-> show ipv6 routes
Legend:Flags:U = Up, G = Gateway, H = Host, S = Static, C = Cloneable, D = Dynamic,
M = Modified, R = Unreachable, X = Externally resolved, B = Discard,
L = Link-layer, 1 = Protocol specific, 2 = Protocol specific
Destination Prefix Gateway Address Interface Age Protocol Flags
-------------------+----------------+--------+-----------------+------------+---------+-----
195:35::/64 fe80::2d0:95ff:fe12:f470 v6if-to-eagle 18h 51m 55s Local UC
212:95:5::/64 fe80::2d0:95ff:fe12:f470 smbif-5 18h 51m 55s Local UC
output definitions
Destination Prefix IPv6 destination address and prefix.
Gateway Address IPv6 address of the gateway used to reach the destination network.
Interface The IPv6 interface name or loopback.
Age Age of the entry. Entries less than 1 day old are displayed in hh:mm:ss
format. Entries more than 1 day old are displayed in dd:hh format.
Protocol Protocol by which the route was learned.
To Next Page
Loading...
