QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-83
policy condition tos
Configures the precedence bits in the Type of Service (ToS) byte value for a policy condition.
policy condition condition_name tos tos_value [mask tos_mask]
policy condition conditioning no tos
Syntax Definitions
conditioning The name of the condition. May be an existing condition name or a new
condition.
tos_value The Type of Service bits value included in the IP header. The three most
significant bits of the byte determine the precedence (i.e, priority) of the
frame (0 is the lowest, 7 is the highest).
tos_mask The mask for the ToS bits, in the range 0–7.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a ToS value from a condition; however, at least one clas-
sification parameter must be associated with a condition.
• If a ToS value is specified, a DSCP value may not be specified.
Examples
-> policy condition cond2 tos 7
Release History
Release 6.6.1; command was introduced.
Related Commands
policy condition Creates a policy condition.
qos apply Applies configured QoS and policy settings to the current configuration.
show policy condition Shows information about policy conditions configured on the switch.
To Next Page
Loading...
