Interswitch Protocol Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 14-7
show amap
Displays adjacent switches and associated MAC addresses, ports, VLANs, IP addresses, and system
names.
show amap
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Remote switches that stop sending Hello packets and are connected to an AMAP switch via a hub may
take up to two times the common transmission time to age out of the AMAP database, and no longer
appear in this show command display.
Examples
-> show amap
AMAP is currently enabled,
AMAP Common Phase Timeout Interval (seconds) = 300,
AMAP Discovery Phase Timeout Interval (seconds) = 30
Remote Host Description = falconCmm
Remote Host Base MAC = 00:00:00:00:00:00
Local Interface = 1/2, VLAN = 200
Remote Interface = 3/1, VLAN = 200
Remote IP Address Configured = 1
2.0.0.10
Remote Host Description = falconCmm
Remote Host Base MAC = 00:d0:95:6b:09:40
Local Interface = 3/1, VLAN = 1
Remote Interface = 6/1, VLAN = 1
Remote IP Address Configured = 1
2.0.0.11
output definitions
AMAP is currently The AMAP status: enabled (default) or disabled. Use the amap com-
mand to change the AMAP status for the switch.
AMAP Common Phase Time-
out Interval (seconds)
The number of seconds to wait between each Hello packet transmission
during the common phase. Use the amap common time command to
change this value.
To Next Page
Loading...
