RIP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 33-9
ip rip interface send-version
Configures the send option for a RIP interface. This defines the type(s) of RIP packets that the interface
will send.
ip rip interface {interface_name} send-version {none | v1 | v1compatible | v2}
Syntax Definitions
interface_name The name of the interface.
none RIP packets will not be sent by the interface.
v1 Only RIPv1 packets will be sent by the interface.
v1compatible Only RIPv2 broadcast packets (not multicast) will be sent by the inter-
face.
v2 Only RIPv2 packets will be sent by the interface.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Using this command will override RIP default behavior.
• Other devices must be able to interpret the information provided by this command or there will not be
proper routing information exchanged between the switch and other devices on the network.
Examples
-> ip rip interface rip-1 send-version v1
Release History
Release 6.6.1; command was introduced.
parameter default
none | v1 | v2 | v1compatible v2
To Next Page
Loading...
