Alcatel-Lucent OmniSwitch 6250 - Show 802.1 X Captive-Portal Configuration

802.1X Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 44-37
show 802.1x captive-portal configuration
Displays the Captive Portal configuration information (session time limit and the number of login retries)
for the specified 802.1x port.
show 802.1x captive-portal configuration [slot/port]
Syntax Definitions
slot/port The slot and port number of the 802.1x port for which you want to
display the configuration.
Defaults
By default, the Capitve Portal session limit and login retry count are displayed for all 802.1x ports if the
slot/port parameter is not specified..
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the slot/port parameter to display the Captive Portal configuration for a specific 802.1X port.
• This command only displays information for 802.1x ports that are configured with a Captive Portal
device classification policy.
Examples
-> show 802.1x captive-portal configuration
802.1x Captive Portal configuration for slot 7 port 11:
Session Limit (hours) = 4,
Login Retry Count = 5,
802.1x Captive Portal configuration for slot 8 port 1:
Session Limit (hours) = 8,
Login Retry Count = 2,
-> show 802.1x captive-portal configuration 8/1
802.1x Captive Portal configuration for slot 8 port 1:
Session Limit (hours) = 8,
Login Retry Count = 2,
output definitions
Session Limit (hours) The length of the Captive Portal session, in hours..
Login Retry Count The number of login retries allowed.