Ethernet OAM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 25-25
ethoam endpoint lowest-priority-defect
Configures the lowest priority fault alarm for the lowest priority defect for a MEP.
ethoam endpoint mep_id domain {domain_name | mac_address} association association_name lowest-
priority-defect lowest_priority_defect
Syntax Definitions
mep_id Specifies the Maintenance Association End Point. The valid range is
1–8191.
domain_name Specifies the domain name. For more information on the different
formats of the domain name, refer to ethoam domain command on
page 25-3.
mac_address Specifies the CFM system MAC address.
association_name Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
lowest_priority_defect The lowest priority defect that can generate a Fault alarm. Possible
values are xcon, rem-err-xcon, no-defect, mac-rem-err-xcon, err-xcon,
and all-defect.
Defaults
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
The mep_id should be unique amid all those used by or available to the service provider in the specified
MA.
Examples
-> ethoam endpoint 100 domain esd.alcatel-lucent.com association alcatel-sales
lowest-priority-defect all-defect
Release History
Release 6.6.1; command was introduced.
parameter default
lowest_priority_defect mac-rem-err-
xcon
To Next Page
Loading...
