QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-89
policy condition destination mac
Configures a destination MAC address for a policy condition.
Note. Specifying a destination MAC address and mask of all zeros (00:00:00:00:00:00) as a policy condi-
tion can result in the switch dropping all traffic. Only use this type of condition in combination with other
policies that will allow desired traffic and/or if a source or destination slot/port is also part of the destina-
tion MAC condition.
policy condition condition_name destination mac mac_address [mask mac_mask]
policy condition condition_name no destination mac
Syntax Definitions
condition_name The name of the condition. May be an existing condition name or a new
condition.
mac_address The destination MAC address in the Layer 2 header of the frame (for
example, 00:20:da:05:f6:23).
mac_mask Optional. The mask for the destination MAC address (for example,
ff:ff:ff:ff:ff:ff).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of the command to remove a destination MAC address from a condition; however, at
least one classification parameter must be associated with a condition.
• A destination MAC address and a destination MAC group cannot be specified in the same condition.
Examples
-> policy condition cond3 destination mac 00:20:da:05:f6:23
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
