Link Aggregation Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 12-17
lacp linkagg partner system id
Configures the MAC address of the remote system’s dynamic aggregate group to which the local switch’s
dynamic aggregate group is attached.
lacp linkagg agg_num partner system id partner_system_id
lacp linkagg agg_num no partner system id
Syntax Definitions
agg_num The number corresponding to the dynamic aggregate group on the
switch.
partner_system_id The MAC address of the remote switch’s dynamic aggregate group in
the hexadecimal format xx:xx:xx:xx:xx:xx.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a partner system ID from a dynamic aggregate group.
• The partner_system_id and the partner_system_priority specify the remote system’s priority.
Examples
-> lacp linkagg 2 partner system id 00:20:da4:32:81
-> lacp linkagg 2 no partner system id
Release History
Release 6.6.1; command was introduced.
parameter default
partner_system_id 0
To Next Page
Loading...
