Configuration File Manager Commands
page 9-4 OmniSwitch 6250 CLI Reference Guide November 2009
configuration error-file limit
Specifies the maximum number of configuration error files allowed in the switch’s /flash directory. Error
files are normally generated when a configuration file is applied to the switch. Error files are identified by
their .err extension.When the maximum number of .err files is exceeded, any new error file will over-
write the .err file with the oldest timestamp.
configuration error-file limit number
Syntax Definitions
number Indicate the number of error files allowed in the /flash directory. The
valid range is from 1 to 25 files.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• When the error file limit is set to 1 (the default value), the next error file generated by the switch will
replace the existing one.
• When the error file limit is set to a value greater than 1, when a new error file that exceeds the
maximum limit is created, the switch will automatically remove the error file with the smallest times-
tamp.
• The error files generated by the switch have the .err extension.
• If you want to save an error file, you may change the file name so that it does not have the .err
extension, or you can move it from the /flash directory.
Examples
-> configuration error-file limit 2
-> configuration error-file limit 1
Release History
Release 6.6.1; command was introduced.
parameter default
number 1
To Next Page
Loading...
