Alcatel-Lucent OmniSwitch 6250 - Policy Condition Destination Port Group

QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-107
policy condition destination port group
Associates a destination port group with a policy condition. Note that this condition is supported only in
combination with a multicast condition (multicast ip, multicast ipv6, or multicast network group).
policy condition condition_name destination port group group_name
policy condition condition_name no destination port
Syntax Definitions
condition_name The name of the condition. May be an existing condition name or a new
condition.
group_name The name of the destination port group. Port groups are configured
through the policy port group command.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the no form of the command to remove a destination port group from a condition; however, at least
one classification parameter must be associated with a condition.
Examples
-> policy condition cond6 destination port group portgr4 multicast ip any
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply Applies configured QoS and policy settings to the current configuration.
policy port group Configures a port group and its associated slot and port numbers.
policy condition Creates a policy condition.
show policy condition Shows information about policy conditions configured on the switch.