IP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 29-59
icmp type
Enables or disables a specific type of ICMP message, and sets the minimum packet gap. The minimum
packet gap is the number of microseconds that must pass between ICMP messages of the same type.
icmp type type code code {{enable | disable} | min-pkt-gap gap}
Syntax Definitions
type The ICMP packet type. This is conjunction with the ICMP code deter-
mines the type of ICMP message being specified.
code The ICMP code type. This is conjunction with the ICMP type deter-
mines the type of ICMP message being specified.
enable Enables the specified ICMP message.
disable Disables the specified ICMP message.
gap The number of microseconds required between ICMP messages of this
type.
Defaults
Platforms Supported
OmniSwitch 6250
parameter default
enable | disable disabled
gap 0
To Next Page
Loading...
