LINK OAM Commands
page 26-38 OmniSwitch 6250 CLI Reference Guide November 2009
show efm-oam port remote detail
Displays the LINK OAM configuration and details of the related parameters of the remote port.
show efm-oam port slot/port remote detail
Syntax Definitions
slot/port Specifies the slot number for the module and the physical port number
on that module (e.g. 3/1 specifies port 1 on slot 3).
Defaults
N/A.
Platforms Supported
OmniSwitch 6250.
Usage Guidelines
N/A.
Examples
-> show efm-oam port 1/1 remote detail
Remote MAC address : 00:30:96:fd:6b:fa,
Remote Vendor (info): 0x15a1
Remote Vendor (oui) : XYZ
Mode : active,
Max OAMPDU size : 1518,
Config Revision : 0,
Functions Supported : loopbackSupportEventSupport
Output fields are described here:
Release History
Release 6.6.1; command was introduced.
output definitions
Remote MAC address Displays the MAC address of the remote peer.
Remote Vendor (info) Displays the vendor number in hexadecimal of the remote peer.
Remote Vendor (oui) Displays the Organizationally Unique Identifier (OUI) number of the
remote peer.
Mode The state of LINK OAM mode on the remote port, active or passive.
Max OAMPDU size Displays the maximum OAMPDU size that the remote LINK OAM
port can support.
Config Revision Displays the configuration revision of the remote LINK OAM port.
Functions Supported Displays the LINK OAM functions supported by the remote port.
To Next Page
Loading...
