Alcatel-Lucent OmniSwitch 6250 - Show Ip Rip

RIP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 33-23
show ip rip
Displays the RIP status and general configuration parameters (e.g., forced hold-down timer).
show ip rip
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show ip rip
Status = Enabled
Number of routes = 9
Host Route Support = Enabled
Route Tag = 42
Update interval = 30
Invalid interval = 180
Garbage interval = 120
Holddown interval = 0
Forced Hold-Down Timer = 0
output definitions
Status RIP status (Enabled or Disabled).
Number of routes Number of network routes in the RIP routing table.
Host Route Support Host route status (Enabled or Disabled). Indicates whether or not RIP
can add host routes (routes with a 32-bit mask) to the RIP table.
Route Tag Route tag value for RIP routes generated by the switch. Valid values are
0–2147483647.
Update interval The RIP routing update interval, in seconds. Valid range is 1–120.
Default is 30.
Invalid interval The RIP invalid timer value, in seconds. Valid range is 3–360. Default
is 180.
Garbage interval The RIP garbage timer value, in seconds. Valid range is 0–180. Default
is 120.