Ethernet Port Commands
page 20-84 OmniSwitch 6250 CLI Reference Guide November 2009
show interfaces hybrid counters errors
Displays interface error frame information (e.g., CRC errors, transit errors, receive errors) for combo
ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} counters errors
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
fiber Specifies that statistics for the SFP port(s) will be displayed.
copper Specifies that statistics for the copper RJ-45 port(s) will be displayed.
Defaults
If a specific slot or slot/port number is not entered with this command, the error frame information for all
switch combo ports is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Enter a slot and port number or a range of port numbers to display information for a specific combo
port or a range of combo ports.
• Enter a slot number to display information for all combo ports on a specific slot.
• These counters do not apply to Gigabit Ethernet traffic.
Examples
-> show interfaces 1/25 hybrid copper counters errors
01/25,
Alignments Errors = 6.45E13, FCS Errors = 7.65E12
IfInErrors = 6435346, IfOutErrors= 5543,
Undersize pkts = 867568, Oversize pkts= 5.98E8
output definitions
Slot/Port Interface slot and port number.
Alignments Errors Number of Alignments errors.
FCS Errors Number of Frame Check Sequence errors.
IfInErrors Number of received error frames.
To Next Page
Loading...
