Loopback Detection Commands
page 17-2 OmniSwitch 6250 CLI Reference Guide November 2009
loopback-detection
Enables or disables Loopback Detection (LBD) globally on the switch.
loopback-detection {enable | disable}
Syntax Definitions
enable Enables LBD on the switch.
disable Disables LBD on the switch.
Defaults
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
• LBD can be enabled globally and per port without any dependency but loopback-detection will be
operational only if LBD is enabled globally and also on the specific port.
• LBD can be configured for a port and the configuration can be applied and retained, whether or not
LBD is enabled globally. However, LBD functionality on a port is available only when LBD is enabled
globally on the switch.
Examples
-> loopback-detection enable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaLdbConfigTable
alaLdbGLobalConfigStatus
parameter default
enable | disable disable
loopback-detection port Enables or disables LBD on a specific port.
show loopback-detection Displays LBD configuration information.
To Next Page
Loading...
