Alcatel-Lucent OmniSwitch 6250 - Ip Multicast Static-Group

IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-13
ip multicast static-group
Creates a static IGMP group entry on a specified port on a specified VLAN.
ip multicast static-group ip_address vlan vid port slot/port
no ip multicast static-group ip_address vlan vid port slot/port
Syntax Definitions
ip_address The IP address of the multicast group.
vid VLAN to include as a static IGMP group.
slot/port The slot/port number you want to configure as a static IGMP group.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove an IGMP static group entry on a specified port on a speci-
fied VLAN.
• The ip multicast static-group command allows you to create an IGMP static group entry on a speci-
fied port on a specified VLAN. This, in-turn, enables that network segment to receive IGMP traffic
addressed to the specified IP multicast group address.
• You can also create an IGMP static group entry on a link aggregate port by entering
ip multicast static-group ip_address vlan vid port, followed by the link aggregation group number
(e.g., ip multicast static-group 11.0.0.1 vlan 2 port 7).
Examples
-> ip multicast static-group 229.10.10.10 vlan 4 port 1/1
-> no ip multicast static-group 229.10.10.10 vlan 4 port 1/1
-> ip multicast static-group 225.11.11.11 vlan 4 port 7
-> no ip multicast static-group 225.11.11.11 vlan 4 port 7
Release History
Release 6.6.1; command was introduced.