IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-65
ipv6 load rip
Loads RIPng into memory. When the switch is initially configured, you must load RIPng into memory to
enable RIPng routing.
ipv6 load rip
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• RIPng will support a maximum of 1,000 routes.
• RIPng will support a maximum of 20 interfaces.
• Use the ipv6 rip status command to enable RIPng on the switch.
Examples
-> ipv6 load rip
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaDrcTmConfig
alaDrcTmIPRipngStatus
ipv6 rip status Enables/disables RIPng routing on the switch.
show ipv6 rip Displays RIPng status and general configuration parameters.
To Next Page
Loading...
