Link Aggregation Commands
page 12-40 OmniSwitch 6250 CLI Reference Guide November 2009
lacp agg partner admin port
Configures the administrative status of a partner port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin port partner_admin_port
lacp agg [ethernet | fastethernet | gigaethernet] slot/port
no partner admin port
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
partner_admin_port The administrative state of the partner port. Possible values are
0–65535.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a partner_admin_port value from a slot and port associ-
ated with a dynamic aggregate group.
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet ports.
Examples
-> lacp agg 2/1 partner admin port 255
-> lacp agg 2/1 no partner admin port
Release History
Release 6.6.1; command was introduced.
parameter default
partner_admin_port 0
To Next Page
Loading...
