VLAN Stacking Commands
page 24-40 OmniSwitch CLI Reference Guide November 2009
show ethernet-service nni
Displays configuration information for VLAN Stacking Network Network Interface (NNI) ports.
show ethernet-services nni [slot/port | linkagg agg_num]
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
agg_num The link aggregate ID number (0–31).
Defaults
By default, all NNI ports are displayed if a slot/port or link aggregate ID number is not specified.
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
Specify a slot/port or link aggregate ID number to display information for a single slot/port or link aggre-
gate ID.
Examples
-> show ethernet-service nni
Port TPID Legacy BPDU
stp gvrp
--------+--------+-----------------------+
1/22 0x8100 Disable Disable
1/23 0x8100 Disable Disable
- show ethernet-service nni 1/23
Port TPID Legacy BPDU
stp gvrp
--------+--------+-----------------------+
1/23 0x8100 Disable Disable
output definitions
Port The slot/port number or link aggregate ID for the NNI port.
TPID The vendor TPID value configured for the NNI port.
stp Whether or not Spanning Tree legacy BPDU processing is enabled for
the NNI port.
gvrp Whether or not GVRP legacy BPDU processing is enabled for the port.
To Next Page
Loading...
