IPv6 Commands
page 30-8 OmniSwitch 6250 CLI Reference Guide November 2009
ipv6 dad-check
Runs a Duplicate Address Detection (DAD) check on an address that was marked as duplicated.
ipv6 dad-check ipv6_address if_name
Syntax Definitions
ipv6_address IPv6 address.
ip_name Name assigned to the interface.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The switch performs DAD check when an interface is attached to the stack and its VLAN first enters the
active state. Use this command to rerun a DAD check on an address that was marked as duplicated.
Examples
-> ipv6 dad-check fe80::2d0:95ff:fe6a:f458/64 Test_Lab
Release History
Release 6.6.1; command was introduced.
Related Commands
N/A
MIB Objects
alaIPv6InterfaceAddressTable
alaIPv6InterfaceAddressDADStatus
To Next Page
Loading...
