IPv6 Commands
page 30-72 OmniSwitch 6250 CLI Reference Guide November 2009
ipv6 rip update-interval
Configures the RIPng update interval. This is the interval, in seconds, that RIPng routing updates will be
sent out.
ipv6 rip update-interval seconds
Syntax Definitions
seconds Interval, in seconds, that RIPng routing updates are sent out. Valid range
is 0–120.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use this command, along with the ipv6 rip jitter command to configure RIPng updates.
Examples
-> ipv6 rip update-interval 30
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaRipng
alaRipngUpdateInterval
parameter default
seconds 30
ipv6 rip jitter Configures an offset value for RIPng updates.
show ipv6 rip Displays RIPng status and general configuration information.
To Next Page
Loading...
