OmniSwitch 6250 CLI Reference Guide November 2009 page 31-1
31 RDP Commands
This chapter details Router Discovery Protocol (RDP) commands for the switch. RDP is an extension of
the Internet Control Message Protocol (ICMP) that provides a mechanism for end hosts to discover at least
one router in the same network.
This implementation of RDP is based on the router requirements specified in RFC 1256. Switches that
serve as a router can enable RDP to advertise themselves to clients on the same network at random inter-
vals between a configurable range of time and in response to client solicitations.
MIB information for the RDP commands is as follows:
Filename: AlcatelIND1Rdp.mib
Module: alcatelIND1RDPMIB
A summary of the available commands is listed here:
ip router-discovery
ip router-discovery interface
ip router-discovery interface advertisement-address
ip router-discovery interface max-advertisement-interval
ip router-discovery interface min-advertisement-interval
ip router-discovery interface advertisement-lifetime
ip router-discovery interface preference-level
show ip router-discovery
show ip router-discovery interface
To Next Page
Loading...
