DNS Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 11-3
ip name-server
Specify the IP addresses of up to three servers to query on a host lookup.
ip name-server server-address1 [server-address2 [server-address3]]
Syntax Definitions
server-address1 The IP address of the primary DNS server to query for host lookup. This
is the only address that is required.
server-address2 The IP address of the secondary DNS server to query for host lookup.
This server will be queried only if the desired host name or host IP
address is not located by the primary DNS server. A second IP address
is optional.
server-address3 The IP address of the DNS server with the lower priority. This server
will be queried only if the desired host name or IP address is not located
by the primary and secondary DNS servers. A third IP address is
optional.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Configuration of the DNS resolver to resolve any host query requires that you first set the default
domain name with the ip domain-name command and enable the DNS resolver function with the ip
domain-lookup command before you specify the IP addresses of the DNS servers by using the ip
name-server command.
• You can configure up to three IPv4 DNS servers and three IPv6 DNS servers in a switch.
Examples
-> ip name-server 189.202.191.14 189.202.191.15 188.255.19.1
-> ip name-server 10.255.11.66
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
