Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-165
show spantree cist vlan-map
Displays the range of VLANs associated with the flat mode Common and Internal Spanning Tree (CIST)
instance.
show spantree cist vlan-map
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command is available when the switch is operating in either the 1x1 or flat Spanning Tree mode.
• Initially all VLANs are associated with the flat mode CIST instance 0 (also known as MSTI 0).
Examples
-> show spantree cist vlan-map
Spanning Tree Cist Vlan map
-----------------------------
Cist
Name :
VLAN list : 1-9,14-4094
Release History
Release 6.6.1; command was introduced.
Related Commands
output definitions
Name An alphanumeric value that identifies the name of the CIST. Use the
bridge msti command to define a name for this instance.
VLAN list The range of VLAN IDs that are associated with the CIST instance.
show spantree mst region Displays the MST region information for the switch.
show spantree msti vlan-map Displays the range of VLANs associated to the specified MSTI.
show spantree map-msti Displays the MSTI that is associated to the specified VLAN
To Next Page
Loading...
