Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-75
show interfaces hybrid pause
Displays the flow control pause configuration for combo ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} pause
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
fiber Specifies that the configuration of the SFP port(s) will be displayed.
copper Specifies that the configuration of the copper RJ-45 port(s) will be
displayed.
Defaults
If a specific slot or slot/port number is not entered with this command, the flow control pause configura-
tion for all switch combo ports is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Enter a slot and port number or a range of port numbers to display information for a specific combo
port or a range of combo ports.
• Enter a slot number to display information for all combo ports on a specific slot.
Examples
-> show interfaces hybrid fiber pause
Slot/Port Active Wait time(usec) Cfg-Pause Cfg-Cross Hybrid Type
-----------+--------+---------------+--------+-----------+-----------
1/25 - 0 DIS MDI -
1/26 - 0 DIS MDI -
-> show interfaces hybrid copper pause
Slot/Port Active Wait time(usec) Cfg-Pause Cfg-Cross Hybrid Type
-----------+--------+---------------+--------+-----------+-----------
1/25 - 0 DIS Auto -
1/26 Active 65535 Tx-N-Rx Auto C
output definitions
Slot/Port Interface slot and port number
Active Interface status.
To Next Page
Loading...
