OmniSwitch 6250 CLI Reference Guide November 2009 page 44-1
44 802.1X Commands
This chapter includes information about commands used for configuring and viewing port-specific 802.1X
parameters. Included in this command set are specific commands used to configure Access Guardian poli-
cies (also referred to as device classification policies) for 802.1X ports.
MIB information for the 802.1X port commands is as follows:
Filename: IEEE_8021X.mib
Module: IEEE8021-PAE-MIB
A summary of the available commands is listed here:
802.1X port commands 802.1x
802.1x initialize
802.1x re-authenticate
802.1x supp-polling retry
802.1x captive-portal address
show 802.1x users
show 802.1x statistics
show 802.1x non-supplicant
Access Guardian commands 802.1x supplicant policy authentication
802.1x non-supplicant policy authentication
802.1x non-supplicant policy
802.1x policy default
802.1x captive-portal policy authentication
802.1x captive-portal session-limit
802.1x captive-portal retry-count
802.1x captive-portal address
802.1x captive-portal proxy-server-url
show 802.1x device classification policies
show 802.1x captive-portal configuration
To Next Page
Loading...
