VLAN Stacking Commands
page 24-2 OmniSwitch CLI Reference Guide November 2009
ethernet-service
Creates a VLAN Stacking VLAN (SVLAN) for tunneling customer traffic, a management SVLAN for
provider traffic, or an SVLAN that the IP Multicast VLAN (IPMV) application will use to distribute multi-
cast traffic.
ethernet-service {svlan | ipmvlan | management-vlan} {svid1[-svid2]} [enable | disable] [[1x1 | flat] stp
{enable | disable}] [name description]
no ethernet-service {svlan | ipmvlan | management-vlan} {svid1[-svid2]}
Syntax Definitions
svlan Creates an SVLAN for tunneling customer traffic.
ipmvlan Creates an SVLAN used by IPMV to distribute multicast traffic.
management-vlan Creates a management SVLAN for provider traffic.
svid1 The VLAN ID number identifying the SVLAN (2–4094).
-svid2 The last VLAN ID number in a range of SVLANs that you want to
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).
enable Enables the SVLAN administrative status.
disable Disables the SVLAN administrative status, which blocks all ports bound
to that SVLAN.
1x1 Specifies that the Spanning Tree status for the SVLAN applies when the
switch is running in the 1x1 Spanning Tree mode.
flat Specifies that the Spanning Tree status for the SVLAN applies when the
switch is running in the flat Spanning Tree mode.
stp enable Enables the SVLAN Spanning Tree status for the service provider
network topology.
stp disable Disables the SVLAN Spanning Tree status for the service provider
network topology.
description An alphanumeric string of up to 32 characters. Use quotes around the
string if the VLAN name contains multiple words with spaces between
them (e.g., “Alcatel-Lucent Engineering”).
Defaults
By default, the Spanning Tree status is enabled in both the 1x1 and flat mode when the SVLAN or IPMV
is created
parameter default
enable | disable enable
stp enable | disable enable
description VLAN ID number
To Next Page
Loading...
