IP Commands
page 29-96 OmniSwitch 6250 CLI Reference Guide November 2009
show ip protocols
Displays switch routing protocol information and status.
show ip protocols
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command also displays the switch’s primary IP address and router ID, if configured, and debug infor-
mation.
Examples
-> show ip protocols
Router ID = 10.255.11.243,
Primary addr = 10.255.11.243,
RIP status = Not Loaded,
Debug level = 1,
Debug sections = error,
Release History
Release 6.6.1; command was introduced.
output definitions
Router ID The set routing ID. The router ID is how the router is identified in IP.
Primary addr The primary interface address the route uses.
RIP status Whether RIP is loaded or not.
Debug level What the current router debug level is.
Debug sections What types of debugging information are being tracked.
To Next Page
Loading...
