Alcatel-Lucent OmniSwitch 6250 - Show Qos Port

QoS Commands
page 38-54 OmniSwitch CLI Reference Guide November 2009
show qos port
Displays information about all QoS ports or a particular port.
show qos port [slot/port] [statistics]
Syntax Definitions
slot/port The physical slot and port number. For example: 3/1.
statistics Displays statistics for high-density gigabit modules.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Information for all ports is displayed unless a particular port is specified.
• Use the qos port command to configure port parameters.
• For ports that are trusted (Yes displays in the Trust field), the Trust field includes one of the following
characters:
Examples
-> show qos port
Slot/ QoS Deflt Queues Bandwidth
Port Act Enabled Trust P/DSCP Deflt Tot Physical Max Reserved Clsfy Type
4/1 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/2 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/3 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/4 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/5 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/6 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/7 Yes Yes No 0/ 0 8 0 100M - -/<phy> - ethernet-100
4/8 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/9 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/10 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/11 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
4/12 No Yes No 0/ 0 8 0 0K - -/<phy> - ethernet
character definition
+ Indicates that the port is manually configured as trusted through the qos
port trusted command; the port setting takes precedence over the global
trust setting configured through the qos trust ports command.
* Indicates that the port is automatically trusted regardless of the global set-
ting set through the qos trust ports command. (Applies to mobile ports and
ports configured for 802.1Q.)