Alcatel-Lucent OmniSwitch 6250 - Page 1483

QoS Commands
OmniSwitch CLI Reference Guide November 2009 page 38-55
-> show qos port 4/7
Slot/ QoS Deflt Queues Bandwidth
Port Act Enabled Trust P/DSCP Deflt Tot Physical Max Reserved Clsfy Type
4/7 Yes Yes No 0/ 0 8 0 100M - -/<phy> - ethernet-100
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaQoSPortTable
alaQoSPortSlot
alaQoSPortPort
alaQoSPortEnabled
alaQoSPortDefault8021p
alaQoSPortDefaultDSCP
alaQoSPortDefaultQueues
alaQoSPortMaximumReservedBandwidth
alaQoSPortMaximumDefaultBandwidth
alaQoSPortDefaultClassification
alaQoSClassify
alaQoSClassifySourceInterfaceType
output definitions
Slot/Port The slot and physical port number.
QoS Whether or not the interface supports QoS.
Act Whether or not the port is sending/receiving QoS traffic.
Enabled Whether or not the port is enabled for QoS.
Trust Whether the port is trusted or not trusted.
Default P The default 802.1p setting for the port.
Default DSCP The default ToS/DSCP setting for the port.
Default Queues The number of default queues.
Tot Queues The total number of queues.
Physical Bandwidth The amount of physical bandwidth available on the port.
Max Reserved Bandwidth Displays the amount of bandwidth reserved and whether it is physical
(<phy>) or maximum virtual port bandwidth (<max>).
Clsfy The default classification setting on a high-density gigabit port (p for
802.1p; t for ToS; d for DSCP). The field displays a hyphen (-) if the
port is not located on a high-density gigabit interface.
Type The interface type, ethernet or wan.
qos port Configures a physical port for QoS.