IP Commands
page 29-48 OmniSwitch 6250 CLI Reference Guide November 2009
ip route-map set ip-nexthop
Configures the IP address of the next hop in a route map.
ip route-map route-map-name [sequence-number number] set ip-nexthop ip_address
no ip route-map route-map-name [sequence-number number] set ip-nexthop ip_address
Syntax Definitions
route-map-name The name of the route map (up to 20 characters).
number A number that links together the route maps. The range is 1–100.
ip_address IP address of the next hop.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to delete the set ip-nexthop parameter in the route map.
• All route maps having the same name but different sequence numbers are linked together and
processed in order of increasing sequence number.
• The route-map-name and sequence-number should exist before you configure this set criteria.
Examples
-> ip route-map 222 sequence-number 50 set ip-nexthop 128.251.17.224
-> no ip route-map 222 sequence-number 50 set ip-nexthop 128.251.17.224
Release History
Release 6.6.1; command was introduced.
parameter default
number 50
To Next Page
Loading...
