Alcatel-Lucent OmniSwitch 6250 - Ssh Enforce Pubkey-Auth

Session Management Commands
page 6-46 OmniSwitch 6250 CLI Reference Guide November 2009
ssh enforce pubkey-auth
Enables or disables Secure Shell public key and password authentication. When enabled, password authen-
tication is not allowed.
ssh enforce pubkey-auth {enable | disable}
Syntax Definitions
enable Enforces only SSH public key authentication.
disable Enforces both SSH public key and password authentication.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Note that if a public key file (i.e., thomas_dsa.pub) exists in the flash/network/pub directory on the
switch, public key authentication is used even if this method of authentication is disabled using this
command. Rename, move, or delete the public key file to ensure that public key authentication is disabled.
Examples
-> ssh enforce pubkey-auth enable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaSshConfigGroup
alaSshPubKeyEnforceAdminStatus
parameter default
enable | disable disable
telnet Invokes a Telnet session. A Telnet session is used to connect to a remote
system or device.
sftp Starts an SFTP session. An SFTP session provides a secure file transfer
method.