IPv6 Commands
page 30-58 OmniSwitch 6250 CLI Reference Guide November 2009
ipv6 access-list
Creates an IPv6 access list that is used to specify multiple IPv6 addresses for a route map configuration.
ipv6 access-list access-list-name
no ipv6 access-list access-list-name
Syntax Definitions
access-list-name Name of the IPv6 access list (up to 20 characters).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the no form of this command to delete the access list.
Examples
-> ipv6 access-list access1
-> no ipv6 access-list access1
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaRouteMapAccessListNameTable
alaRouteMapAccessListName
alaRouteMapAccessListNameIndex
alaRouteMapAccessListNameAddressType
alaRouteMapAccessListNameRowStatus
ipv6 access-list address Adds IPv6 addresses to an existing IPv6 access list.
show ipv6 access-list Displays the contents of an IPv6 access list.
To Next Page
Loading...
