File Management Commands
page 7-32 OmniSwitch 6250 CLI Reference Guide November 2009
newfs
Deletes a complete /flash file system and all files within it, replacing it with a new, empty /flash file
system. Use this command when you want to reload all files in the file system or in the unlikely event that
the /flash file system becomes corrupt.
newfs /flash
Syntax Definitions
/flash Required syntax. This indicates that the complete flash file system will
be replaced.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• It is recommended that you preserve all required image and configuration files by saving them to a
remote host before executing the newfs command.
• Do not power-down the switch after running the newfs command until you reload all required image
and configuration files.
• This command can also be used on the secondary CMM.
Examples
-> newfs /flash
Release History
Release 6.6.1; command was introduced.
Related Commands
N/A
MIB Objects
systemServices
systemServicesArg1
systemServicesAction
To Next Page
Loading...
