LINK OAM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 26-17
efm-oam errored-frame-period
Configures the threshold, window frame values and the status for notification when the number of frame-
errors exceed the threshold in a given period of time (specified) by window. When the number of frame
errors exceeds a threshold within a given window defined by a number of frames (for example, 10 frames
out of 1000 had errors), an Errored Frame Period event is generated.
efm-oam port slot/port[-port2] errored-frame-period [threshold threshold_symbols] [window
window_frames] [notify {enable | disable}]
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
-port2 The last port number in a range of ports that you want to configure on
the same slot. (e.g. 3/1-4 specifies ports 1,2,3 and 4 on slot 3).
threshold_symbols Specifies the frame error threshold number. The range supported is 1 to
maximum 4 byte integer value (4294967295).
window_frames Specifies the number of frames used to define a window within which
the frame period errors are measured.
enable Enables notification of the Errored Frame Period event.
disable Disables notification of the Errored Frame Period event.
Defaults
The default for window_frames depends on the port-types. The default, minimum and maximum
supported values for various port-types are:
Platforms Supported
OmniSwitch 6250.
parameter default
threshold_symbols 1 frame error
enable | disable enable
port-type default value minimum value maximum value
100 mbps 200000 20000 12000000
1000 X 2000000 200000 120000000
1000 T 2000000 200000 120000000
10 Gig 20000000 2000000 1200000000
To Next Page
Loading...
