IP Commands
page 29-76 OmniSwitch 6250 CLI Reference Guide November 2009
ip dos trap
Sets whether the switch generates SNMP DoS traps when an attack is detected.
ip dos trap {enable | disable}
Syntax Definitions
enable Enables the generation of DoS traps.
disable Disables the generation of DoS traps.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command controls whether the switch generates an SNMP trap when a DoS attack is detected. It is
assumed a DoS attack has occurred when the port scan penalty threshold is exceeded. This value is set
using the ip dos scan threshold command.
Examples
-> ip dos trap enable
-> ip dos trap disable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaDoSConfig
alaDoSTrapCnt1
parameter default
enable | disable enable
ip dos scan threshold Sets the threshold for the port scan value, at which a DoS attack is
recorded.
show ip dos config Displays the configuration parameters of the DoS scan for the
switch.
To Next Page
Loading...
