QoS Policy Commands
page 39-52 OmniSwitch CLI Reference Guide November 2009
policy condition multicast network group
Associates a multicast group with a policy condition.
policy condition condition_name multicast network group multicast_group
policy condition condition_name no multicast network group
Syntax Definitions
condition_name The name of the condition.
multicast_group The multicast group name. Multicast groups are configured through the
policy network group command.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of the command to remove a multicast group from a condition; however, at least one
classification parameter must be associated with a condition.
• A multicast address and a multicast network group cannot be specified in the same condition.
Examples
-> policy condition cond3 multicast group video2
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply Applies configured QoS and policy settings to the current configuration.
policy condition Creates a policy condition.
policy network group Configures a network group name and its associated IP addresses.
show policy condition Shows information about policy conditions configured on the switch.
show policy network group Displays information about policy network groups.
To Next Page
Loading...
