IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-85
show ipv6 rip peer
Displays a summary of the observed RIPng peers, or specific information about a peer when a peer
address is provided.
show ipv6 rip peer [ipv6_addresss]
Syntax Definitions
ipv6_addresss IPv6 address of the peer.
Defaults
N/A.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
If you do not specify a peer, all IPv6 RIP peers are displayed.
Examples
-> show ipv6 peer
Seen on Packets Last
Address Interface Recv Update
-----------------------------+-------------+--------+----------
fe80::200:39ff:fe1f:710c vlan172 23 20
fe80::2d0:95ff:fe12:da40 bkbone20 33 2
fe80::2d0:95ff:fe12:da40 vlan150 26 25
fe80::2d0:95ff:fe6a:5d41 nssa23 20 25
-> show ipv6 rip peer fe80::2d0:95ff:fe12:da40
Peer#1 address = fe80::2d0:95ff:fe12:da40,
Seen on interface = bkbone20,
Last Update = 8 secs,
Received packets = 33,
Received bad packets = 0
Received routes = 5,
Received bad routes = 0
Peer#2 address = fe80::2d0:95ff:fe12:da40,
Seen on interface = vlan150,
Last Update = 1 secs,
Received packets = 27,
Received bad packets = 0
Received routes = 2,
Received bad routes = 0
To Next Page
Loading...
