802.1AB Commands
page 13-6 OmniSwitch 6250 CLI Reference Guide November 2009
lldp notification interval
Sets the time interval that must elapse before a notification about the local system MIB change is
generated.
lldp notification interval seconds
Syntax Definitions
seconds The minimum number of seconds for generating a notification-event.
The valid range is 5-3600.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The LLDP protocol and notification must be enabled before using this command.
• In a specified interval, generating more than one notification-event is not possible.
Examples
-> lldp notification interval 25
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
lldpConfiguration
lldpNotificationInterval
parameter default
seconds 5
lldp notification Specifies the switch to control per port notification status about the
remote device change.
show lldp local -system Displays local system information.
To Next Page
Loading...
