Loopback Detection Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 17-3
loopback-detection port
Enables or disables LBD on a specific port.
loopback-detection port slot/port [-port2] {enable | disable}
Syntax Definitions
slot/port The slot number and the physical port number of the module that is
being configured for LBD.
-port2 Specifies the last port in the range of ports.
enable Enables LBD on the specified port.
disable Disables LBD on the specified port.
Defaults
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
• Loopback Detection must be enabled globally to enable LBD functionality on a specific port.
• LBD can be configured for a port and the configuration can be applied and retained, whether or not
LBD is enabled globally. However, LBD functionality on a port is available only when LBD is enabled
globally on the switch.
Examples
-> loopback-detection port 1/1 enable
-> loopback-detection port 1/1-8 enable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable
To Next Page
Loading...
