Chassis Management and Monitoring Commands
page 2-18 OmniSwitch 6250 CLI Reference Guide November 2009
reload all
Reloads (i.e., reboots) all Network Interfaces (NIs) and Chassis Management Module (CMMs).
reload all [in [hours:] minutes | at hour:minute [month day | day month]]
reload all cancel
Syntax Definitions
in [hours:] minutes Optional syntax. Schedules a reload of all modules to take effect in the
specified minutes or hours and minutes within the next 24 hours.
at hour:minute Optional syntax. Schedules a reload of all modules to take place at the
specified time using a 24-hour clock. If you do not specify the month
and day, the reload takes place at the specified time on the current day
provided the specified time is later than the time when the CLI
command is issues. If the specified time is earlier than the current time,
the reload will take place on the following day.
month day | day month The name of the month and the number of the day for the scheduled
reload. Specify a month name and the day number. It is unimportant if
the month or day is first. See examples below for further explanation.
cancel Cancels a pending time delayed reload.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> reload all
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
