DHCP Relay Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 32-59
show ip udp relay service
Displays current configuration for UDP services by service name or by service port number.
show ip udp relay service [BOOTP | NBDD | NBNSNBDD | DNS | TACACS | TFTP | NTP | port]
Syntax Definitions
BOOTP BOOTP/DHCP well-known ports 67/68.
NBDD NBDD well-known port 138.
NBNSNBDD NBNS/NBDD well-known ports 137/138.
DNS DNS well-known port 53.
TACACS TACACS well-known port 65.
TFTP TFTP well-known port 69.
NTP NTP well-known port 123.
port A user-specified port that is not a well-known port.
Defaults
By default, the configuration for all UDP services is shown.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Enter a service name or port number with this command to display information about an individual
service.
• When specifying a port number, do not specify a well-known port number. Instead, use the service
name for the well-known port (i.e., NBNS/NBDD, DNS, etc.).
Examples
-> show ip udp relay service
Service Port(s) Description
---------+--------+------------------
1 67 68 BOOTP/DHCP
4 53 DNS
5 65 TACACS
-> show ip udp relay service dns
Service Port(s) Description
---------+--------+------------------
453DNS
To Next Page
Loading...
