LINK OAM Commands
page 26-6 OmniSwitch 6250 CLI Reference Guide November 2009
efm-oam port mode
Configures the LINK OAM mode on the port or on the range of ports to active or passive.
efm-oam port slot/port[-port2] mode {active | passive}
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
-port2 Specifies the last port in the range of ports.
active Configures the LINK OAM mode to active.
passive Configures the LINK OAM mode to passive.
Defaults
By default, LINK OAM mode is set to active on all ports.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• LINK OAM discovery process is never initiated from a port when it is in passive mode. At least one of
the two peer ports should be in active mode.
• An active port will respond to Loopback-control OAMPDUs only if the peer EFM-OAM client is also
in active mode.
Examples
-> efm-oam port 1/1 mode active
-> efm-oam port 1/1 mode passive
-> efm-oam port 2/1-10 mode active
-> efm-oam port 2/1-4 mode passive
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
