QoS Policy Commands
page 39-42 OmniSwitch CLI Reference Guide November 2009
policy condition destination ip
Configures a destination IP address for a policy condition.
policy condition condition_name destination ip ip_address [mask netmask]
policy condition condition_name no destination ip
Syntax Definitions
condition_name The name of the condition.
ip_address The destination IP address of the Layer 3 flow.
netmask The mask for the destination IP address.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If a mask is not specified, the IP address is assumed to be a host address.
• A destination IP address and a destination IP network group cannot be specified in the same condition.
• Use the no form of the command to remove a destination IP address from a condition; however, at least
one classification parameter must be associated with a condition.
Examples
-> policy condition cond4 destination ip 208.192.21.0 mask 255.255.255.0
Release History
Release 6.6.1; command was introduced.
Related Commands
policy condition Creates a policy condition.
qos apply Applies configured QoS and policy settings to the current configuration.
show policy condition Shows information about a particular policy condition configured on the
switch.
To Next Page
Loading...
