IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-3
ipv6 interface
Configures an IPv6 interface on a VLAN.
ipv6 interface if_name vlan vid [enable | disable]
[base-reachable-time time]
[ra-send {yes | no}]
[ra-max-interval interval]
[ra-managed-config-flag {true | false}]
[ra-other-config-flag {true | false}]
[ra-reachable-time time]
[ra-retrans-timer time]
[ra-default-lifetime time | no ra-default-lifetime]
[ra-send-mtu] {yes | no}
no ipv6 interface if_name
Syntax Definitions
if_name IPv6 interface name.
vlan Creates a VLAN interface.
vid VLAN ID number.
base-reachable-time time Base value used to compute the reachable time for neighbors reached
via this interface.
ra-send Specifies whether the router advertisements are sent on this interface.
ra-max-interval interval Maximum time, in seconds, allowed between the transmission of unso-
licited multicast router advertisements in this interface. The range is 4 -
1,800.
ra-managed-config-flag Value to be placed in the managed address configuration flag field in
router advertisements sent on this interface.
ra-other-config-flag Value to be placed in the other stateful configuration flag in router
advertisements sent on this interface.
ra-reachable-time time Value, in milliseconds, to be placed in the reachable time field in router
advertisements sent on this interface. The range is 0 - 3,600,000. The
special value of zero indicates that this time is unspecified by the router.
ra-retrans-timer time Value, in milliseconds, to be placed in the retransmit timer field in
router advertisements sent on this interface. The value zero indicates
that the time is unspecified by the router.
To Next Page
Loading...
