File Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 7-33
rcp
Copies a file from a primary to a non-primary switch in a stack and vice versa.
rcp [slot:] source_filepath [slot:] destination_filepath
Syntax Definitions
slot The slot number of the non-primary switch in a stack.
source_filepath The name and path of the source file.
destination_filepath The name and path of the destination file.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
On switches in a stack configuration, this command copies a file from any non-primary switch to the
primary switch in a stack. You must specify the slot number on these switches.
Examples
-> rcp 3:/flash/file.txt file.txt
-> rcp /flash/working/file.txt 3:/flash/working/file.txt
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
chasSupervisionRfsLsTable
alcatelIND1ChassisSupervisionRfsCommands
chasSupervisionRfsCommandsSlot
chasSupervisionRfsCommandsCommand
chasSupervisionRfsCommandsSrcFileName
chasSupervisionRfsCommandsDestFileName
rrm Removes a file from a secondary CMM or from a non-primary switch in
a stack.
rls Displays the content of a non primary CMM in a switch or a non-pri-
mary switch in a stack.
To Next Page
Loading...
