Alcatel-Lucent OmniSwitch 6250 - Show Udld Configuration Port

UDLD Commands
page 27-14 OmniSwitch 6250 CLI Reference Guide November 2009
show udld configuration port
Displays the configuration information for all UDLD ports or for a particular UDLD port on the switch.
show udld configuration port [slot/port]
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
Defaults
By default, a list of all UDLD ports is displayed.
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
N/A
Examples
-> show udld configuration port
Slot/Port Admin State Oper Mode Probe-Timer Echo-Wait-Timer
-----------+---------------+------------+-------------+----------------
1/1 disabled normal 15 10
1/2 disabled normal 45 10
1/17 disabled normal 33 8
1/18 disabled normal 33 8
1/19 disabled normal 33 8
1/20 disabled aggresive 55 8
1/21 disabled aggresive 55 8
1/22 disabled aggresive 55 8
1/41 disabled aggresive 77 8
1/42 enabled aggresive 77 8
1/43 enabled aggresive 77 8
1/44 enabled aggresive 77 8
1/45 enabled aggresive 77 8
-> show udld configuration port 1/44
Global UDLD Status : enabled,
Port UDLD Status : enabled,
Port UDLD State : bidirectional,
UDLD Op-Mode : aggresive,
Probe Timer (Sec) : 77,
Echo-Wait Timer (sec) : 8