UDLD Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 27-15
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaUdldGlobalStatus
alaUdldPortConfigTable
alaUdldPortConfigUdldOperationalStatus
alaUdldPortConfigUdldMode
alaUdldPortConfigUdldStatus
alaUdldPortConfigUdldProbeintervalTimer
alaUdldPortConfigUdldDetectionPeriodTimer
alaUdldPortNeighborStatsTable
alaUdldNeighborName
output definitions
Slot/Port Slot number for the module and physical port number on that module.
UDLD-State Indicates the state of interface determined by UDLD operation, which
can be notapplicable, shutdown, undetermined or bidirectional.
Oper-Mode Indicates the operational mode of UDLD protocol. Options include
normal or aggressive.
Global UDLD Status Indicates the UDLD status on the switch. Options include enabled or
disabled.
Port UDLD Status Indicates the UDLD status on a port. Options include enable or dis-
able.
Probe Timer The probe-message expected after this time period.
Echo-Wait Timer The detection of neighbor is expected with in this time period.
udld mode Configures the operational mode of UDLD on a specific port, a range of
ports, or all the ports.
udld probe-timer Configures the probe-message advertisement timer on a specific port, a
range of ports, or all the ports.
udld echo-wait-timer Configures the echo based detection timer on a specific port, a range of
ports, or all the ports.
To Next Page
Loading...
