Link Aggregation Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 12-9
lacp linkagg size
Creates a dynamic aggregate group that uses the Link Aggregation Control Protocol (LACP) to establish
and maintain link aggregation. The size parameter is required to create the link aggregate group.
lacp linkagg agg_num size size
[name name]
[admin state {enable | disable}]
[actor admin key actor_admin_key]
[actor system priority actor_system_priority]
[actor system id actor_system_id]
[partner system id partner_system_id]
[partner system priority partner_system_priority]
[partner admin key partner_admin_key]
no lacp linkagg agg_num
Syntax Definitions
agg_num The number corresponding to the dynamic aggregate group. Must be a
unique integer in the range 0–31.
size The maximum number of links that may belong to the aggregate. Values
may be 2, 4, or 8.
name The name of the dynamic aggregate group. May be any alphanumeric
string up to 255 characters long. Spaces must be contained within
quotes (e.g., “Dynamic Group 1”).
enable Specifies that the dynamic aggregate group is active and is able to
aggregate links.
disable Specifies that the dynamic aggregate group is inactive and not able to
aggregate links.
actor_admin_key The administrative key value associated with the dynamic aggregate
group. Possible values are 0–65535.
actor_system_priority The priority of the dynamic aggregate group. Possible values are
0–65535.
actor_system_id The MAC address of the dynamic aggregate group on the switch.
partner_system_id The MAC address of the remote system’s aggregate group to which the
switch’s aggregate group is attached.
partner_system_priority The priority of the remote system to which the aggregation group is
attached. Possible values are 0–65535.
partner_admin_key The administrative key for the aggregation group’s remote partner.
Possible values are 0–65535.
To Next Page
Loading...
