Link Aggregation Commands
page 12-10 OmniSwitch 6250 CLI Reference Guide November 2009
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a dynamic aggregate group from the configuration.
• The maximum number of link aggregate groups allowed on the switch (static and dynamic combined)
is 32.
• If the dynamic group has any attached ports, you must disable the group with the lacp linkagg admin
state command before you can delete it.
• Optional parameters for the dynamic aggregate group may be configured when the aggregate is created
or the dynamic aggregate group may be modified later.
• Use the static linkagg size command to create static aggregate groups. See page 12-3 for more infor-
mation about this command.
Examples
-> lacp linkagg 2 size 4
-> lacp linkagg 3 size 2 admin state disable actor system priority 65535
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alclnkaggAggTable
alclnkaggAggNumber
alclnkaggAggSize
alclnkaggAggLacpType
alclnkaggAggName
alclnkaggAggAdminState
alclnkaggAggActorAdminKey
alclnkaggAggActorSystemPriority
alclnkaggAggActorSystemID
alclnkaggAggPartnerSystemID
alclnkaggAggPartnerSystemPriority
alclnkaggAggPartnerAdminKey
parameter default
enable | disable enable
show linkagg Displays information about static and dynamic (LACP) aggregate
groups.
To Next Page
Loading...
